Skip to main content

Search This Blog

MedSpace

Home
Pharmacology
Quality Assurance
Production
News
Protocol

Posts

Showing posts from March, 2017

Primary Antibody Intro | Western Blotting

Get link
Facebook
Twitter
Pinterest
Email
Other Apps

By MedSpace - March 07, 2017

Western Blotting Technique: 1. Primary Antibody Introduction

Powered by Blogger

Theme images by Michael Elkan

Copyright 2018@MedSpace

Author

Dewan Md. Sumsuzzman

Archive

November1
January1
November2
October1
July2
June11
May3
April1
June1
May1

April1
March1
November7
September6
August18
December3
November7
October12
September6
July2

Show more Show less

Labels

articles
Bioclock & Aging
bulk holding study
cheese
Cleaning Validation
Download
ELISA
Failure Mode and Effect Analysis
fermentation
Food tech

Guidelines
Inje University
Irisin
Lab protocol
news
Pharmacology
Ppt
presentation
production
protocol
Q&A
quality assurance
Root cause analysis
RTPCR
Science
SOP
Western Blotting

Show more Show less

Popular posts from this blog

Storage and Cleaning Procedure of Dies & Punches

By Unknown - August 10, 2016

Tooling Storage: Ø Store Tooling in Dies & Punches room in designated racks with tooling storage rack label after applying a thin smear of lubricant oil over the punch and die surface. Ø Fill out a new Tooling Storage Rack Label for new set with the following information: a) Rack number b) Set Number c) Product name & Strength d) Punch dimensions e) Punch specification f) Tooling D/B/BB g) Quantity h) Embossing on Upper punch i) Embossing on Lower punch j) Checked by NOTE: For plain tooling, meaning there is no embossing on the face of the tooling, the word “plain” shall be noted. Ø Once all verifications are complete, attach the tooling set inspection report together and file in the production office. Ø The tooling reference should be updated by the production executive for locating the punch set giving following details:- 1. Product Name, 2. Rack N

Cleaning Validation | Campaign Cleaning Validation (CCV)

By Unknown - September 01, 2016

When the product demand does not allow for a complete clean up after each batch, a campaign cleaning validation must be conducted. A back to back cleaning is performed between batches in a campaign, and a complete cleaning at the end of a campaign. Sampling of the equipment is performed after the last batch in a campaign, and all test results must meet predetermined acceptance criteria as per campaign cleaning validation protocol. Samples for residual active may be taken after back to back cleanings where possible, for information only . Microbiology samples may be taken after back to back cleanings in a campaign to ensure that there is no excessive microbial growth on the equipment.

Blending | Effective Sampling During Process Validation | Optimize Sampling Location

By Unknown - December 07, 2015

Important of sampling during blending: Sampling plays a great role in achieving the accurate results of analysis. Sampling must and procedure must be defined in validation protocols and training should be provided to the concerned staff before the validation activities start. Samples are representative of the whole batch. So it should be handled and weight carefully because segregation may occur during weighing and transpiration. Sample quantity should not be more than the required and whole mass sample should be used in the analysis. Fig: Blending Machine Sampling for blend: Blends are tested for their homogeneity. Homogeneity of the blend is critical for the quality of the final product. The sample should be taken from at least 10 locations in the blender. The sampling location should be selected according to the difficulty of the blending. Ares of poor blending must be covered in sampling. Corners and discharged point must have sampling location.

Total Pageviews